QRSS Mite Beacon Kit

Link to more details, instructions, and free software/drivers

Please note you will need to configure the QRSS Mite via computer to start with (Free software) after this its standalone (read the instructions above BEFORE you order)

You will also need a standard USB-A to USB -C data cable, you may already have this. Many Cables are only Charge cables and do not allow data to be past via them. make sure you use a real Data cable , we offer a suitable low cost one here.

The building instructions are the same as the Whisper mite , the difference is firmware and swap of the front plates. see the seperate QRSS Setup and User guide

The Kanga QRSS Mite (KQM) is an inexpensive, easy‑to‑use way to explore low‑power QRSS beaconing operation. Once configured it runs standalone — no PC required — and needs only a simple wire antenna and a 5 V DC supply (phone charger or battery pack) to get on the air.

3 versions :

Low Band version 60m and 40m ( 40m is the most popular band around the world)

Mid band Version 30m and 20m

High Band Version 15m, 12m, or 10m 

Note power output is less as the band increases, 15m will still give you near to 200mW , 12m is around 150mW and 10m is around 100mW

Comes with a mini FREE power checker kit!

Key Features

•            Standalone operation — configure via the USB socket once, then the KQM runs independently.

•            Compact power — runs from a 5 V supply and delivers about 200 mW on 40 m, slightly more on 60 m.

•            Simple configuration — choose QRSS mode and idle pattern using a simple terminal emulator on the Kanga QRSS/Whisper Mite web page.

•            Precise timing — built‑in RTC with TXCO and battery backup keeps accurate time; a single front‑panel Sync button aligns the unit quickly.

•            Real results — low power plus a basic end‑fed half‑wave antenna is all that is needed.